ECCOBOND G757HF電子組裝/ECCOBOND G757HF電子組裝/ECCOBOND G757HF電子組裝/ECCOBOND G757HF電子組裝/ECCOBOND G757HF電子組裝/ECCOBOND G757HF電子組裝/ECCOBOND G757HF電子組裝/ECCOBOND G757HF電子組裝/ECCOBOND G757HF電子組裝/ECCOBOND G757HF電子組裝/ECCOBOND G757HF電子組裝/ECCOBOND G757HF電子組裝/ECCOBOND G757HF電子組裝/ECCOBOND G757HF電子組裝/ECCOBOND G757HF電子組裝/ECCOBOND G757HF電子組裝/ECCOBOND G757HF電子組裝/ECCOBOND G757HF電子組裝/ECCOBOND G757HF電子組裝/工業膠水/電子組裝膠水/工業用膠
技術服務熱線：021-51693135 / 021-22818476
G757HF photocurable adhesive is designed for highthroughput assembly operations.
TYPICAL PROPERTIES OF UNCURED MATERIAL
Density , g/cm3 1.15
Sag Resistance (45o angle), mm:
@ 25oC 1.88
@ 150oC 3.1
Shelf Life @ 0°C, months 6
Flash Point - See MSDS
TYPICAL CURING PERFORMANCE
Cure Schedule
45 minutes @ 140°C
20 minutes @ 160°C or
10 minutes @ 180°C or
Post Cure
2 to 4 hours at the highest expected use temperature
This product generates high heat during cure. No adverse exothermeffects are obtained when cured in bond thicknesses less than orabout 0.125 inches (3.2 mm).The above cure profiles are guideline recommendations. Cureconditions (time and temperature) may vary based on customers'experience and their application requirements, as well as customercuring equipment, oven loading and actual oven temperatures.
Storage Store product in the unopened container in a dry location.Storage information may be indicated on the product containerlabeling.Optimal Storage: 0°C. Storage greater than or below 0°Ccan adversely affect product properties.
G757HF可光固化粘合劑專為高吞吐量組裝操作。
固化材料的典型特性
密度，g /cm31.15
阻力（45o角），mm：
@25oC1.88
@150oC3.1
保質期0°C，月6
閃點 - 參見MSDS
典型的固化性能
治愈時間表
在140°C 45分鐘
在160°C或20分鐘
180°C或10分鐘
后治
在*高預期使用溫度下2至4小時本產品在固化過程中產生高熱量。沒有不利的放熱當焊接厚度小于或等于或小于固化時，可獲得效果約0.125英寸（3.2mm）。以上治療方案是準則建議。治愈條件（時間和溫度）可能會根據客戶的經驗及其應用要求，以及客戶固化設備， |
免責聲明：以上所展示的信息由會員自行提供，內容的真實性、準確性和合法性由發布會員負責，www.qy6.com對此不承擔任何責任。如有侵犯您的權益，請來信通知刪除。